NEW Enlight 430W Power Supply, Upgrade for HPS-300-101 EN-8304942 7237 Case

Description

en430w upgrade for HPS300101


NEW Enlight® 843H2001A 430W ATX Dual-Rail 12V 2.0 Upgrade Power Supply for HPS-300-101 EN-8304942

Upgrade your power supply in EN-7237 Case




Key Features:

  • 430 Watts output.
  • Supports PCI-Express video card
  • Supports up to four (4) SATA drives
  • High Capacity Dual 12V Rail Output
  • Offically certified by: FCC, UL, cUL, CE, and C-TICK
  • Built-in Quad Output Protection
  • Backward compatible with Enlight EN-8304942, HPS-300-101






Connectors Summary

1x 20pin & 24pin dual-use main connector
3x PATA Peripheral Power Connector
1X Floppy Drive Power Connector
4X Serial ATA Power Connector (90-degree type, will go into any tight corner)
1X 4-pin ATX12V Power Connector
1X PCI-Express 6pin Power Connector



Physical Dimensions

150(W) x 86(H) x 140(D) mm


Extra Electrical Protection:
Input Protection:
In primary circuit of the power supply , a protected fuse is inserted. Only internal fault of the power supply will cause the fuse to be blown.
Output Protection:
Over Voltage Protection: The +5V/+12V/+3.3V DC outputs are protected against the over voltage condition . Maximum value can't be over 6.8V at 5V terminal ,15.6V at 12V and 4.5V at 3.3V.
Over Power Protection: As a protection against excessive power delivery due to output short circuit or over load usage, this power supply can electronically limit the output current to not surged to exceed 60% of its designed output power.
Short Circuit Protection: Short circuit placed on any DC output will shut down all DC outputs and latch. After that, the unit may need to be removed from system or unused for some time before it can be used again.
Over Current Protection: Current protection is designed to limit the current to ensure the system operate within safe operating conditions. The recommended over current protection scheme is for the power supply to latch into the shutdown state. After that, the unit may need to be removed from system or unused for some time before it can be used again. The setting of over current protection for each output rail is as following: +5V is less than or equal to 50A , +3.3V is less than or equal to 60A,+12V is less than or equal to 40A.


$29.99